GSO ISO 3739-1:2024
ISO 3739-1:2022
Gulf Standard
Current Edition
·
Approved on
14 October 2024
Industrial tyres and rims — Part 1: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Designation, dimensions and marking
GSO ISO 3739-1:2024 Files
No files for this standard are available in the store currently.
GSO ISO 3739-1:2024 Scope
This document specifies the main requirements of the metric series of pneumatic tyres primarily intended for industrial vehicles, including designations, dimensions and markings. The tyres are based on the following parameters:
— speeds not exceeding 50 km/h;
— use on 5° tapered or flat base rims.
The conversion of code-designated industrial tyres into metric-designated tyres is outside the scope of this document.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
BH GSO 42:2015
GSO 42:2015
Bahraini Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
BH GSO 159:2015
GSO 159:1993
Bahraini Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
Recently Published from Mechanical Sector
GSO 1796:2007
Gulf Standard
Methods of test for two pieces aluminum round cans used for canning food (Beverages & stuffs
GSO 230:2005
Gulf Standard
MOTOR VEHICLES —
BRAKE FLUID – SIMULATED SERVICE
PERFORMANCE TEST
GSO 137:1991
Gulf Standard
Plastics and cellular plastics – Part 1: standard atmospheres for Conditioning and testing, Determination of linear dimensions and Test for dimensional stability
GSO 1584:2002
Gulf Standard
Agricultoral equipment - roll over protection structures for agricultural tractors.